Thickness of plate heat exchanger
2018-12-26 Source: Author: Anonymous read: 【Print this page】
The plate heat exchanger believes that you have a certain understanding of it through the previous introduction, so do you know the thickness of the plate heat exchanger? It does n’t matter if you do n’t understand, let ’s introduce it to you, let ’s take a look.
The thickness of the plate heat exchanger plate is basically 0.4mm ~ 0.8mm. The thickness of the plate heat exchanger is mainly determined by the working pressure. The higher the working pressure requirement and the thicker the plate thickness, the higher the production cost. Conversely, the lower the value, users need to decide according to their own needs. Basically, there are more plates with 0.5mm and 0.6mm.
Most boards are designed to facilitate the bonding of gaskets. Therefore, the smooth surface design is adopted at the joint between the plate and the gasket. This smooth surface groove design often results from the user's lack of understanding of the plate heat exchanger, and due to the imbalance in the use of power and maintenance during maintenance. It is too large to cause plate damage and scrap the entire plate heat exchanger. Therefore, care must be taken when servicing plate heat exchangers with smooth grooves.
1. Whether the plate and gasket were selected correctly when buying the plate heat exchanger for the first time.
2. Whether there are filters installed at the two inlets of the plate heat exchanger.
3. Whether the water tower on the cooling water side is cleaned regularly (the so-called cleaning, just drain the water within a fixed time, use simple tools to clean up the dirt in the water tower, do not use chemicals to pour directly into the cleaning).
The above is all the contents of the plate heat exchanger introduced to everyone, I hope to bring you some help.